Macurco GBC Manual
3.2 General Wiring Information
All the connectors in GBC are spring tightening and will accept wire from 14 to 24 AWG.
3.2.1 Connecting the wires to terminals:
1. Strip each wire back 1/4 in. (6.5 mm).
2. Press down the white button of the connector.
3. Fully insert the bare wire into the wire cavity of the connector.
Note: When inserting the wire, make sure that the wire insulation is not inhibiting the wire from
contacting the wire contact points inside the terminal connector.
Note: When the wire is properly stripped and inserted in the terminal connector, there should not be
any bare wire exposed.
4. Release the white button.
5. Ensure that the wire cannot be easily pulled out of the connector.
REV – 1.2
[34-2900-0690-7]
8 |
P a g e