Advertisement
In the event of a fault occurring during operation, check below to see if
the fault is due to an operator error. You can repair the following faults
yourself.
1. It is not switched on properly,
The appliance does
not run.
2. The thermostat knob is set on "0".
3. The supply voltage is too low.
1. The appliance is too full of food.
The temperature inside
2. The appliance is located too near
the appliance is not
cool enough.
3. The door is not properly closed or
Excessive noise
from the appliance.
If none of these circumstances applies and you are not able to repair
the fault, please contact a service agent:-
PHONE 1300 729 948
or the plug is not inserted properly
into the socket.
a source of heat.
is opened too frequently.
The appliance is not standing
securely on the ground.
6
THERMOSTAT
The knob graduations are: 0, 1, 2, 3, 4, 5, 6, 7.
The numbers on the thermostat do not stand for the
actual temperature. The larger the number, the colder
the temperature inside and vice versa.
Usually, it is best to start the thermostat in position
1 - 3 then turn it to a higher setting if required.
Position '0' is off.
STORING FOOD
The temperatures in different positions
inside the refrigerator vary. Thus when
storing food, select the appropriate
position to meet your needs.
The coldest position is '1' and the
warmest is '5'.
ICE-MAKING
When making ice,add water to the ice tray
until 4/5 full with the grid in it and place it
on the bottom of the icebox. Twist the tray
or place it briefly in warm water to remove
the ice cubes.
NOTE
Do not use a knife or sharp
instrument when removing the ice
tray.
1
5
2
4
3
3
Advertisement
