Safety precautions When using this appliance, always exercise the following basic safety precautions. 1. Read all of the instructions before using this appliance. 2. Use this appliance only for its intended purpose as described in this User's Manual. 3. This cabinet must be properly installed in accordance with the installation in- structions before it is used.
Please save these instructions. Risk of child entrapment. Before you discard your old cabinet, take off the doors so that children may not easily climb inside. Thank you for using our product. This manual will guide you in getting the best use of your cabinet.
Table of contents Safety precautions Parts Installation Unpacking Leveling Proper air circulation Electrical requirements Features and use Initial set up Temperature adjustment Shelving Interior light Normal operating sounds Proper care and cleaning Cleaning and maintenance Power interruptions Vacation and moving care Lamp replacement Troubleshooting...
Parts 1. Lamp shade 2. Thermostat knob 3. Light switch 4. Handle 5. Leveling bolt 6. Shelf...
Installation Unpacking 1. Remove all packaging material, including the foam base and all adhesive tape holding the cabinet accessories inside and outside. Slide out and remove plastic or foam guard used to secure the compressor from shipping dam- age due to vibration and shock. 2.
Shelf The shelves are designed for both aesthetics and cleaning efficiency. The shelves can be removed and relocated. Especially, these shelves prevent bottles from contacting the evaporator. Light For the sake of decoration and practical operation, a mild light bulb is installed in the cabinet. The light is controlled by the switch on the fan shield.
Proper care and cleaning Cleaning and maintenance Warning: Caution: General: To avoid electric shock, always unplug your cabinet before cleaning. Ignoring this warning may result in fatal or serious injuries. Before using cleaning products, always read and follow manufacturer's instructions and warnings to avoid personal injury or product damage.
Door gasket: Clean the door gasket once every three months to keep it clean and pliable for proper seal. Power interruptions When occasionally power supply is interrupted due to thunder- storms or other causes, remove the power cord from the outlet. When power has been restored, plug the power cord to the outlet.
Lamp replacement Holder step 2 step 3 Lamp holder Lamp tube Lamp cover step 1 step 4 1. Loosen the lug slightly and remove the lampshade. (Step 1) 2. Remove the U lamp tube from the holder. (Step 2) 3. Place a new lamp tube to the holder. (Step 3) 4.
Troubleshooting Cabinet does not operate. Verify if the cabinet is properly plugged in. Verify if the power is supplied. Inside temperature appears too high. Frequent door openings. Short storage period Verify if the gaskets is in good condition The condenser coils need cleaning. Verify if the thermostat is properly adjusted.
Moisture buildup on interior or exterior of the door. This is normal during high humidity periods. Prolonged or frequent door openings. Check door gaskets for proper seal. Cabinet door does not shut properly. Level the cabinet. Check for blockages e.g. beverage bottles, shelves.