Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
Regularly check guard for worn, loose, or damaged parts. If you find any of these conditions DO NOT USE THE GUARD.
9
Failure to do so may cause severe injury!
Keep the guard free of dirt and debris.
9
DO NOT add to or modify any part of the guard. Doing so will void your warranty.
8
DO NOT use the guard for purposes other than those it was designed for.
8
Clean guard with water and mild detergent.
9
Always refer to the safety instructions provided in your floor press instruction manual.
9
WARNING! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. INTRODUCTION
Lightweight aluminium frame with tough steel mesh. Adjustable guard protects the user and/or passer by from being injured if workpiece is
accidently dislodged under load. Bolts onto either side of the table and features five height increments, allowing the workpiece to be placed onto
table with no obstruction. One-way spring loaded locking clips then allow the guard to be pulled up quickly and snap straight into position for full
protection.
3. SPECIFICATION
Model No: ................................................................ YKSG20
Applications: ............................................ YK209F, YK20FFP
Model No: ................................................................ YKSG30
Applications: ............................. YK30F, YK30FAH, YK30FFP
Model No: ................................................................ YKSG50
Applications: ......................... YK509F, YK509FAH, YK50FFP
Model No: ................................................................ YKGS75
Applications: .......................................... YK759F, YK759FAH
4. ASSEMBLY/ OPERATION
4.1.
Choose which side of the floor press to fit the guard, fix the guard support brackets to the
table using the pre-drilled holes and fixings provided. See figs.1&2.
Ensure the brackets are fitted with the locks on the outside and the correct way up as fig.1.
fig.1
Guard Support
Guard Support
Bracket Fixings
Bracket Fixings
Ensure The Correct
Ensure The Correct
Orientation Of The
Orientation Of The
Locking Mechanism
Locking Mechanism
© Jack Sealey Limited
SAFETY GUARD FOR PRESSES
YKGS20, 30, 50, 75
MODEL NO'S:
Original Language Version
Rear
Rear
View Of
View Of
Bracket
Bracket
Fixings
Fixings
fig.2
YKSG20, 30, 50, 75 Issue:2 (H,F) 07/04/22