Fuel And Evaporative Emissions Control System - HUSTLER TrimStar Operator's Manual

B
A. Filter
Figure 4-3
Refer to the Hustler TrimStar
®
125364) for complete hydraulic oil and filter change proce-
dures.

Fuel and Evaporative Emissions Control System

IMPORTANT: Refer to the Safety section of this manual for
fuel handling safety information.
IMPORTANT: Refer to the engine owner's manual for addi-
tional emissions control information.
Use only Hustler approved replacement parts.
®
Your evaporative emission control system may include
parts such as:
• fuel tanks
• fuel lines
• fuel line fittings
• fuel caps
• carbon canisters
• canister mounting brackets
• carburetor purge port connection
• filters
• vapor hoses
• clamps, control valves
• control solenoids
• electronic controls
• vacuum control diaphragms
• purge valves
• liquid/vapor separator
• other associated components
125360CE
A
B. Filter guard
General Service Manual (P/N
®
Use of replacement parts not equivalent to the
original parts may result in system failure and
pose a safety hazard.
The 18.9 liter fuel tank is located behind the engine.
Figure 4-4
A. Fuel tank
B. Fuel cap
Park the mower on level ground before filling the fuel tank.
Clean the area around the fuel cap before removing the
cap. Remove the fuel cap slowly.
When threading the fuel cap onto the filler neck, tighten the
cap until it begins to click, then, continue to turn it until at
least three clicks are heard.
IMPORTANT: Do not overfill the fuel tank. The fuel tank
should be filled no higher than the bottom of the fill neck.
Figure 4-4 The fuel system is designed to leave room for the
fuel to expand with fuel temperature changes. Stop filling the
tank after the fuel nozzle automatically clicks off.
Overfilling the fuel tank may cause the following:
• Engine damage
• Fire hazard!
4-3
B
C
A
C. Fuel neck
Figure 4-4
CZ
DA
DE
EN
ES
FR
IT
NL
PT
SV
REV A