GE FHV5SGWW Service Manual page 10

Installation and Accessory Parts
l Do not over fill freezer for proper internal air circulation.
Electrical Requirement
l Make sure there is a suitable power Outlet (220V) with proper grounding to power the
freezer.
l Avoid the use of three plug adapters or cutting off the third grounding in order to
accommodate a two-plug outlet, this is a dangerous practice since it provides no effective
grounding for the freezer and may result in shock hazard.
Install Limitations
l Do not install your freezer in any location not properly insulated or heated e.g. garage etc,
your freezer was not designed to operate in temperature settings below 32
l Select a suitable location for the freezer on a hard even surfaces away from direct sunlight
or heat source e.g. radiators, baseboard heaters, cooking appliances etc, Any floor
unevenness should be corrected.
Installing Casters(delete?)
Your freezer can be equipped with casters for easy moving. We recommend
installing casters before using the freezer. Install following these easy steps:
1.Remove the food basket from the freezer.
2.Slowly tilt the freezer on its side.
3.Tap one caster into the bottom of the freezer. Fasten the caster into place
with screws provided.
4.Install the other three casters in the same manner.
5.Return the freezer to its upright position and replace the food basket.
Note: It is important to wait for 24 hours after installation before plugging in
the unit to allow the refrigerant to stabilize.
Initial Setup
Operating Your Freezer
PDF created with pdfFactory trial version
Freezer
INSTALLATION AND ACCESSORY PARTS
９
www.pdffactory.com
Model:FHV5SGWW/FHV7SGWW
·
Fahrenheit.