Advertisement
STEP 2: Drill Holes
•
Line up the Grab Bar Mounting plate on the wall.
•
Mark where the wall studs are.
•
Mark the holes,
WARNING: ELECTRICAL SHOCK HAZARD. When
drilling into walls, always ensure that you avoid all
electrical wires, cables, ducts, pipes and/or plumbing.
Failure to do so could result in death, serious injury, or
property damage.
STEP 3: Install Grab Bar
•
Screw or fasten the Grab Bar to the wall.
Fasteners for Wooden Studs: Use two (2) wood screws per stud, supplied in
this kit.
Fasteners for Steel Studs: Use at least two (2) fasteners per wall stud. Use high
quality strong fasteners with a 1/4-inch (6 mm) fastener screw diameter. Toggle
bolts are a good option.
Fasteners for No Studs: If wall studs are not suitably placed, See Step 1.
INSTALLER NOTE: To ensure water does not seep into the holes you drilled, put
silicone caulking onto the back of the mounting plate before you screw the grab
bar to the wall.
STEP 4: Install Mounting Plate Cover
•
Snap the mounting plate cover onto the mounting plate.
Page 4 | KRATOS CAPTO V GRAB BAR with SafetyGrip® KCVSG750
Advertisement
