Behringer WASP DELUXE Quick Start Manual page 48

48
WASP DELUXE
WASP DELUXE Eurorack Installation
The WASP DELUXE synthesizer can be removed from its factory
chassis and installed into a standard Eurorack chassis (not
supplied). The module width is 70HP.
We recommend that this procedure is undertaken only by
experienced service technicians, to prevent personal injury, or
damage to the unit.
The Eurorack case will need its own suitable power supply unit to
power the WASP DELUXE synthesizer.
A 10-pin connector on the rear of the main PCB of the WASP
DELUXE allows the +12 VDC power supply connection to be made.
A 10-pin to 16-pin adapter ribbon cable is supplied to connect to
your power supply.
Before proceeding, make sure that your power supply
is capable of supplying +12 VDC, 1 Amp.
Make sure that the connections using the supplied
adapter cable will supply the ground and power to
the correct pins of X23.
Procedure
Follow all steps in the order in which they are presented.
1. Disconnect the power cord and all other
connections to the WASP DELUXE.
2. Undo the 8 screws on the top panel as shown. There is
no need to undo any other screws.
Disconnect from
Main PCB
3. Disconnect the two cables from the lower side of
the main PCB of the WASP DELUXE, and remove the
assembly from the chassis.
4. Store the chassis assembly and the power supply
adaptor in a dry safe place.
5. Securely connect the 10-pin end P1 of the supplied
adapter cable to connector X23 on the Main PCB of the
WASP DELUXE.
X21 No Connection
X23
Supplied Eurorack Power Supply Cable, Part # A74-0001-79446
Connect End P1 to Connector X23 on main PCB
P1
Red Stripe
2 1
10 9
400 mm ± 10
6. Make sure your power supply is turned off
and disconnected from the AC mains.
7. Make sure that your power supply will supply
the following to the pins of connector X23, as
shown in the diagram above:
Pins Connection
1 and 2 No Connection
3 to 8 Ground
9 and 10 +12 VDC
Pins 1 and 2
No Connection
Pins 3 to 8
Ground
Pins 9 and 10
+12 VDC
P2
1 2
15 16