Using The Module Box - Lauda LRZ 913 Operation Manual

5.2

Using the module box

Fig. 6: LiBus module box, catalog no.
LCZ 9727
V1
You can extend LAUDA constant temperature equipment by two additional
module slots using the LiBus module box. The module box is designed for
interface modules with a large cover and is connected to constant tem-
perature equipment via a vacant LiBus socket.
The socket on the constant temperature equipment bears the label LiBus.
Please observe the following installation sequence:
1. Switch off the constant temperature equipment.
2. Disconnect the cable on the module box from the constant tem-
perature equipment.
The module box is disconnected from the power supply.

3. Check which interfaces are already present on the constant tem-
perature equipment and module box.
Observe the information on interface module compatibility.
Only install an interface module with the same type of inter-
face if operation with several of these interfaces is permitted.
4. Install the required interface module in the module box. Please read
the information on installing the module box in the constant tem-
perature equipment, see chapter "Installing the interface module".
5. Position the module box close to the constant temperature equip-
ment.
6. Connect the cable on the module box to the LiBus socket on the
constant temperature equipment.
The interfaces on the module box are ready for operation.

Interface module LRZ 913 13 / 39