Table of Contents
Advertisement
8.2.19. Remove the Contact metals
1. Remove the screws (×14
2. Remove the Contact metal side (L, R).
3. Remove the screws (×15
4. Remove the Contact metal bottom.
8.2.20. Remove the C1-Board
1. Disconnect the flexible cables (CB1, CB2, CB3, CB4,
CB5, CB6 and CB7).
2. Disconnect the flexible cable (C10).
3. Disconnect the connectors (C14 and C15).
4. Remove the screws (×5
8.2.21. Remove the C2-Board
1. Disconnect the flexible cables (CB8, CB9, CB10, CB11,
CB12, CB13, CB14 and CB15).
2. Disconnect the flexible cables (C20, C21 and C22).
3. Remove the screws (×6
).
).
) and remove the C1-Board.
) and remove the C2-Board.
8.2.22. Replace the Plasma panel
Caution:
Place the Plasma panel on a flat surface of a table
(covered by a soft cloth) and a cushion.
A new Plasma panel itself without Contact metals is fragile.
To avoid the damage to new Plasma panel, carry a new
Plasma panel taking hold of the Contact metals.
1. Place a carton box packed a new Plasma panel on the
flat surface of the work bench.
2. Open a box and without taking a new Plasma panel.
3. Attach the Cabinet assy and each P.C.Board and so on,
to the new Plasma panel.
26
Advertisement
Table of Contents
