Kärcher TRS-SSG-503537 E/G Manual page 17

PRESSURE WASHER OPERATING INSTRUCTIONS
ON
START
OFF
98013300-12
STEP 7: Turn the key to the START
position, and hold it there until the
engine starts. If the engine fails to
start within 5 seconds, release the
key, and wait at least 10 seconds
before operating the starter again.
Using the electric starter for more
than 5 seconds at a time will
overheat the starter motor and
can damage it.
When the engine starts, release the
key, allowing it to return to the ON
position. If the choke knob has been
pulled to the CLOSED position to
start the engine, gradually push it
to the OPEN position as the engine
warms up.
High
Pressure
Nozzle
Variable Pressure
Control Handle
98013300-28
Selection of high or low pressure is accompanied by
turning the handle. NOTE: High pressure nozzle must
be inserted at end of wand to obtain high pressure. To
apply soap, read detergent instructions.
Burner
Switch
Engine
Switch
STEP 8:Turn the burner switch
"ON". Turn thermostat dial to the
desired temperature setting.
Brass Soap Nozzle
Variable Pressure
Wand (VP)
Trigger
Kärcher TRS-SSG • Operators • 9.801-330.0-J
Thermostat
98013300-9
98013300-13
STEP 9: Before installing pressure
nozzle, trigger spray gun to elimi-
nate trapped pressure. Then run
machine, allowing water to flush
through the system until clear.
Safety
Latch
WARNING! Never replace noz-
zle without engaging the safety
latch on the spray gun trigger.
98013300-14
17