Advertisement
Quick Links
Advertisement
Related Manuals for CNP Brands Disney Baby SIMBA Jumpee
Summary of Contents for CNP Brands Disney Baby SIMBA Jumpee
- Page 1 SIMBA Jumpee Introduce your little character to ours Model #025010-358...
-
Page 2: Safety Precautions
Safety Precautions Before assembling this jumper, read and understand the instructions. Incorrect assembly may make the jumper unsafe. Do not use this jumper if any part is broken, torn or missing. Keep instructions in a safe place for future reference. WARNING FALL HAZARD;... - Page 3 Due to variations in the style and design of our products, the photographs and illustrations shown in this instruction manual are generic, therefore product fabrics, colour and design may vary from images shown. CNP Brands reserves the right to alter product specifications without notice as a result of our ongoing policy of product improvement.
-
Page 4: Assembly Contents
Assembly Contents Check what you have received... You have received 1 box. Please check the contents of the box against the list below. If anything is missing, please contact Customer Service. In Australia, contact CNP Brands on 1300 667 137, in New Zealand contact Wainhouse Distribution on 0800 567 5000. - Page 5 Assembly Contents Front Foot Back Leg Hanging Toys Screw...
- Page 6 Assembly / Operating Instructions Assembling Seat Support PLEASE NOTE: You may need the help of another adult. Base Assembly Attach the two front feet to the base frame using (2) screws as shown. Leg Assembly Insert (2) front legs and (2) back legs into feet on base frame as shown, making sure to match the letters on the legs (A-D) to the letters on the...
- Page 7 Assembly / Operating Instructions Assembling jumper (continued) Seat Ring Position the simba head toward the front feet opening as shown. Insert the straps from each leg into the corresponding slot on the seat ring marked A,B,C,and D, securing them with seat to put lining on seat ring instruction’s needed the slider clips as shown in the insert illustrations.
- Page 8 Assembly / Operating Instructions Assembling jumper (continued) Seat Height Adjustment To adjust the seat height, pull the slider clip out of the slot on the underside of the seat ring and move the clip to the desired loop on the strap and reinsert the clip into the slot on the tray.
- Page 9 Assembly / Operating Instructions Seat Cover Remove the seat pad from the seat ring by pressing inward on the tabs that are hooked on the lip on the underside of the seat ring and pushing upward until the seat pad is free of the seat ring. On the underside of the seat, remove the 8 elastic loops from the corresponding hooks to free the fabric for cleaning.
-
Page 10: Care Instructions
Remove batteries prior to placing unit in storage to prevent battery leakage/corrosion to battery compartment. Use only those parts and accessories approved by CNP Brands. If you have any difficulties in assembling the swing, please contact our Service Department. In Australia, contact CNP Brands on 1300 667 137. - Page 12 Distributed in Australia by CNP Brands Distributed in New Zealand by 20 Calarco Drive, Wainhouse Distribution Derrimut, VIC, 3030 2-6 Argyle St, Morningside, Customer Service 1300 667 137 PO Box 41-014, St Lukes, Auckland, New Zealand W: www.cnpbrands.com.au Customer Service: 0800 567 5000 E: info@cnpbrands.com.au...
Need help?
Do you have a question about the Disney Baby SIMBA Jumpee and is the answer not in the manual?
Questions and answers