Connecting To A Wps Network - Denon HOME SUBWOOFER Owner's Manual

Contents Connections
The power turns off and the status LED flashes in red
The power turns off and the status LED flashes in red.
The protection circuit has been activated due to a rise in temperature within this unit. Unplug the power cord, wait about an hour until this unit cools
0
down sufficiently, and then turn the power on again.

Connecting to a WPS network

Connecting to a WPS network.
If your wireless router support WPS (Wi-Fi Protected Setup™) this unit can optionally connect to your network using the push button method by
0
following these steps:
(Wi-Fi Protected Setup™ is trademarks of Wi-Fi Alliance.)
1. Press the WPS button on your router.
2. Within 2 minutes, press and hold the CONNECT button on the rear panel of this unit for 5 seconds.
3. The LED on the front of this unit will flash green for several seconds as it connects to your WPS router.
4. When the connection is complete, the LED on the front of this unit will turn solid blue.
Settings Tips
18
Status LED Appendix