Related Manuals for Haier HW-24CE03
Summary of Contents for Haier HW-24CE03
-
Page 1: Operation Manual
WINDOW TYPE ROOM AIR CONDITIONER OPERATION MANUAL HW-24CE03 HW-24CI03 Please read this operation manual before using the air conditioner. No.0010548435... -
Page 2: Table Of Contents
Contents Contents ... 2 Cautions ..3 Safety Instructions ... 4 Preparation ... 5 Part Names ... 6-7 Operation Guide ... 8-9 Maintenance ... 10 Tips for Energy Saving ... 11 For Trouble Free Operation ... 11 Trouble shooting ... 12 Important! Please Read Before Starting ... -
Page 3: Cautions
Installation Location We recommend that this air conditioner be installed properly by qualified installation technicians in accordance with the Installation Instructions provided with the unit. Before installation, check that the voltage of the electric supply in your home or office is the same as the voltage shown on the nameplate. -
Page 4: Safety Instructions
- it is very dangerous. CAUTION Do not turn the air conditioner on and off from the power mains switch. Use the ON/OFF operation switch. Do not stick anything into the air outlet of the unit. -
Page 5: Preparation
Preparation Disposal of your old air conditioner Before disposing of an old air conditioner that goes out of use, please make sure it is inoperative and safe. Unplug the air conditioner in order to avoid the risk of child entrapment. -
Page 6: Part Names
Parts Name Machine body Operation panel Ventilation lever Temp. setting Thermostat switch MODEL: HW-24CE03 VENTILATOR Temp. setting Mode selection Auto swing WAIT 3 MINUTES BEFORE RESTARTING Auto swing switch VENTILATOR Auto swing Mode selection switch Front panel Air inlet (indoor side) -
Page 7: Part Names
Parts Name Machine body Operation panel Ventilation lever Temp. setting Thermostat switch MODEL: HW-24CI03 Auto swing switch VENTILATOR Auto swing WAIT 3 MINUTES BEFORE RESTARTING Mode selection switch Air inlet (outdoor side) Front panel Air outlet (indoor side) Operation panel Air inlet (indoor side) Cabinet Mode selection... -
Page 8: Operation Guide
Hint When the mode selection switch is turned to " the air conditioner will only blow out air without cooling. If the mode selection switch is turned from cooling mode to fan mode, do not turn it back until at least 3 minutes have elapsed. -
Page 9: Operation Guide
Otherwise, the fuse may blow due to overload. Do not exceed the selection range. This switch controls the preset indoor temperature to make the air conditioner start or stop automatically, so as to reduce power consumption and operate the system both comfortably and economically. -
Page 10: Maintenance
(2) Open the air inlet. (3) Hold the handle at lower part of the air filter and draw outward to remove the air filter. For HW-24CE03: (1) Loose the air filter by pushing " PUSH " at both ends of air inlet. -
Page 11: Tips For Energy Saving
For longer and trouble-free operation of the unit, pay special attention to the following: Install the air conditioner at a location strong enough to support the unit. Leave enough space around the air inlet and outlet for better circulation. Avoid sites where flammable gas leaks. -
Page 12: Troubleshooting
Troubleshooting Condition Is plug firmly inserted? Is fuse burned out? Doesn't Is there power failure? operate Is thermostat switch incorrectly adjusted? Is there direct sunlight into the room? Is mode selection switch set to fan mode? No cool air or Are doors or windows left poor cooling open? -
Page 13: Important! Please Read Before Starting
Replace them immediately. DO NOT change the internal wiring or any part of the system. DO NOT turn the air conditioner on and off by plugging and unplugging. Use the Operation switch. When Transporting Be careful when picking up and moving the air conditioner. -
Page 14: Installation Instructions
3. The wiring method should comply with local wiring standards. 4. After installation, the power plug should be easy to access. 5. The breaker of the air conditioner should be an all-pole switch (25A) and the distance between its two contacts should be no less than 3mm. -
Page 15: Installation Guide
3. Remove the air conditioner from its packing carton. 4. Place the air conditioner on the metal support. 5. Stuff gaps in the wall or window with soft sponge material or rubber gaskets to block outside noise and keep cool air from escaping.