Haier HSU-24HEA03 Operation Manual page 7

Parts and Functions
1.CODE
Used to select CODE A or B with a press,A or B
will be displayed on LCD.
Please select A without special explanation.
2.RESET
When the remote controller appears abnormal,
use a sharp pointed article to press this button
to reset the remote controller normal.
3.LIGHT button
Control the lightening and extinguishing of
the indoor LED display board.
4. TIMER button
Used to select TIMER ON, TIMER OFF,
TIMER ON-OFF.
5. CLOCK button
Used to set correct time.
6. HEALTH button
Used to set healthy operation.
7. MODE button
AUTO COOL DRY
8. HOUR button
Used to set clock and timer setting.
9. SWING button
Used to select up or down air sending direction.
10. ON/OFF button
Used for unit start and stop.
NOTE: The following functions and related displays are not available: 20
Cooling only unit do not have displays and functions related with heating
19
28
POWER/SOFT
30
FAN HEAT
Display board
31 11 15 23
16
11. TIMER ON display
12. FAN SPEED display
LOW MED
13. LOCK display
14. SWING UP/DOWN display
15. SLEEP display
16. HEALTH display
17. Operation mode display
Operation mode
Remote controller
Display board
18.Singal sending display
19. POWER/SOFT display
20. Left/right air flow display
21. TEMP display
Remote controller: to display the TEMP. setting.
22. TIMER OFF display
23. CLOCK display
24. TEMP button
Used to select your desired temperature.
25. FAN button
Used to select fan speed: LOW,MED, HI, AUTO.
26. HEALTH AIRFLOW button
Used to set the health airflow mode.
27. SLEEP button
Used to select sleep mode.
28. SET button
Used to confirm timer and clock settings.
29. POWER/SOFT button
Use to set power/soft function.
30. LOCK
Used to lock buttons and LCD display. If pressed, the
other buttons will be disabled and the lock condition
display appears. Press it once again, lock will be
cancelled and lock condition display disappears.
31. Remote signal receiver
6
21 17
HI AUTO
AUTO COOL DRY HEAT FAN