Table of Contents
Advertisement
Operation
Timer On-Off Operation
Remote Controller
o
C
ON
OFF
AM
AM
TEMP
ON
OFF
SWING
MODE
SLEEP
HEALTH AIRFLOW
FRESH
HEALTH
CLOCK
SET
TIMER
STERILIZE
4
LIGHT
LOCK
RESET CODE
Set clock correctly before starting TIMER operation.
1. After unit starts, select your desired operation mode
Operation mode will be displayed on LCD.
2. Timer mode selection
Press TIMER button to change TIMER mode. Every time
the button is pressed, display changes as follows:
Remote controller:
Then select your desired TIMER mode (TIMER ON - OFF).
"
"will flash.
3.Time setting
Press HOUR
Every time the button is pressed, time setting
increases 1 min, if kept depressed, it will increase rapidly.
Every time the button is pressed, time setting
FAN
decreases 1 min, if kept depressed, it will decrease rapidly.
It can be adjusted within 24 hours.
4.Timer confirming for TIMER ON
After setting correct time, press TIMER button to confirm
6
"
" on the remote controller stops flashing.
"
" starts flashing.
Time displayed: Unit starts or stops at x hour x min.
5.Time setting for TIMER OFF
Just press HOUR button ,follow the same procedure in
"Time setting for TIMER ON"
6.Time confirming for TIMER OFF
After time setting,press SET button to confirm.
"
" on the remote controller stops blinking.
Time displayed:Unit stops at x hour x min.
To cancel TIMER mode
Just press TIMER button several times until TIMER
mode disappears.
According to the Time setting sequence of TIMER ON
or TIMER OFF, either Start-Stop or Stop-Start can be
achieved.
TIMER ON
TIMER OFF
button.
17
BLANK
TIMER ON-OFF
Advertisement
Table of Contents
