Startup; Operation And Use - Beem Air Joy Hot & Cool User Manual

Air Joy Hot & Cool
In addition, the appliance is protected
against overheating. This switches off the
appliance to prevent overheating when
an ambient temperature of approx. 30° C
is reached. This temperature is reached
quickly if the appliance is located in a
confined space. Therefore, allow sufficient
space so that air can circulate.
If the appliance switches off after over-
heating, proceed as follows:
Switch off the main switch of the ap-
‹
pliance and pull the plug out of the
mains socket. Allow the appliance and
surroundings to cool down.
Switch on the appliance again manu-
‹
ally when the temperature of the appli-
ance and the surroundings has fallen.
NOTE
► If the overheat protection switches
off the appliance, the appliance does
not switch back on again automati-
cally - even after the surrounding
temperature has fallen. You must
switch the appliance back on manu-
ally.
► If you manually switch on the ap-
pliance again and it switches back
off after a few seconds, neither the
temperature of the appliance nor its
surroundings has fallen sufficiently.
22

Startup

Plug the appliance into the mains
‹
socket.
Insert the batteries (not supplied) into
‹
the remote control according to cor-
rect polarity.

Operation and use

Switching the appliance on/off
To switch off the appliance, proceed as
follows:
Move the main ON/OFF switch on the
‹
pedestal to the "I" position.
Press the
‹
panel (5) once to switch the appliance
to cold air. The blue indicator lamp
lights bars 1, 2 or 3 depending on the
airflow set.
Press the
‹
panel (5) twice to switch the appliance
to warm air. The three bars remain red
ALWAYS.
To switch off the appliance, proceed as
follows:
If the appliance does not produce a
‹
cold airflow, press the
twice. The blue indicator lamp extin-
guishes.
If the appliance produces a warm air-
‹
flow, press the
red indicator lamp extinguishes.
Move the main ON/OFF switch (3) on
‹
the pedestal to the "0" position.
BEEM - Elements of Lifestyle
EN
button on the control
button on the control
button
button once. The