Layout And Items Supplied - EINHELL TC-MS 2513 L Original Operating Instructions

•
Never load the machine so much that it cuts
out.
•
Always clamp the workpiece securely on the
saw table with a workpiece clamping device
in order to prevent the workpiece wobbling or
twisting.
•
Ensure that the off-cuts can be removed to
the side of the saw blade. Otherwise it is pos-
sible that they will be caught by the saw blade
and be catapulted out of the machine.
•
Never saw more than one workpiece at any
one time.
•
Never remove loose splinters, chips or jam-
med pieces of wood when the saw blade is
running.
•
To rectify faults or remove jammed pieces of
wood, always switch off the machine first. Pull
out the power plug!
•
Carry out retooling work, adjustments, mea-
surements and cleaning jobs only when the
motor is switched off. Pull out the power plug!
•
Switch off the motor and pull the power plug
before you leave the workplace.
•
Damaged or faulty safety devices have to be
replaced immediately.
•
Damaged safety devices and parts must be
repaired or replaced by an authorized service
center.
•
Have damaged switches replaced by a custo-
mer service workshop.
•
This tool complies with the pertinent safety
regulations. Only a qualified electrician using
original replacement parts is are allowed to
carry out repairs. Failure to observe this point
may result in accidents for the user.
•
Refit all guards and safety devices immedia-
tely after you have completed any repairs or
maintenance work.
•
Be sure to observe the safety information
and operating and maintenance instructions
issued by the manufacturer, as well as the
dimensions listed in the Technical Data.
•
It is imperative to observe the accident pre-
vention regulations in force in your area as
well as all other generally recognized rules of
safety.
•
Operation in enclosed areas is permitted
only with a suitable vacuum extraction sys-
tem.
•
Do not use any low-powered machines for
heavy duty work.
•
Do not use the cable for purposes for which it
is not designed!
•
Check that the moving parts are in good wor-
king order, that they do not jam, and that no
Anl_TC_SM_2513_L_SPK8.indb 37 Anl_TC_SM_2513_L_SPK8.indb 37
GB
parts are damaged. Make sure that all parts
are fitted correctly and that all other operating
conditions are properly fulfilled.
•
Caution: Take extra care when making double
miter cuts!
Please keep these safety instructions in a
safe place

2. Layout and items supplied

2.1 Layout (Fig. 1/2)
1. Release lever
2. Handle
3. ON/OFF switch
4. Machine head
5. Saw blade
6. Movable blade guard
7. Stop rail
8. Turntable
9. Stationary base plate
10. Locking grip
11. Locking blade
12. Tightening screw
13. Workpiece support
14. Debris bag
15. Scale
16. Safety pin
17. Scale (turntable)
18. Movable stop, dependent on table angle
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
- 37 -
15.10.15 09:50 15.10.15 09:50