Advertisement
Available languages
Available languages
EN
Indicates electrical shock hazard.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Wear ear and eye protection
Variable speed control
Before operating the machine
•
Check the following:
•
Do the voltage of the machine correspond
with the mains voltage
•
Are the mains lead and the mains plug in
a good condition.
•
Do not use extension cables which are too
long. Use extension cables with a core
diameter of 1.5 mm
the cable is rolled out completely.
•
In case of a blockage, switch of the machine
immediately.
•
Always compare the maximum rotation speed
of accesoires with the maximum speed of the
p ercussion drill.
•
Pull the mainsplug from the socket before you
change a drill or accessory.
•
Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
When operating the machine
•
C heck if the switch is placed in the 'OFF'-position
before you connect the machine to mains.
•
Keep the mains cable away from moving parts
of the machine.
•
First switch off the machine before you move
the machine downwards along your body.
•
Never cover the ventilation slots.
Immediately switch off the machine in case of:
•
Excessive sparking of the brushes and
verticiliosis in the collector.
•
Malfunction of the mainsplug, -socket or
damaged cables.
•
Broken switch.
•
Smoke or smell caused by scorched insulation.
Electrical safety
When using electric machines always observe
the safety regulations applicable in your country to
28
minimal and only when
2
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions. Keep these
instructions in a safe place!
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class II machine – Double insulation –
You don't need any earthed plug.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely.
3. ASSEMBLy
Use only sharp drills of the following types
Fig.B
Concrete/masonry Hard metal
Metal
Wood
Mounting accessories
Fig.C
Prior to mounting an accessory always
unplug the tool.
Placing and removing bits
In addition to bits the machine can also hold screw
bits with a hexagonal shaft.
•
Loosen the chuck by rotating the handgrip
(A).
•
Insert the drill/bit into the chuck.
•
Tighten the chuck so that the drill/bit is firmly
clamped.
. When using a cable
2
HSS
HSS
Advertisement
