Bahco BCL32SP1 Original Instructions Manual page 8

7. OPERATING INSTRUCTIONS
Removing or Installing Battery Pack
1. Always switch off the machine before insertion or removal of the
2. To remove the battery pack, push the button on the battery pack and
3. To insert the battery pack, align the tool unit slides with the battery
4. Do not force the battery pack in sliding it into tool unit. If the battery
Charging the Battery Pack
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown
3. Push the battery pack into place and make sure the red light on the
4. A fter finish the charging cycle, the light will turn into green. The
5. Your new battery pack is not charged. You need to charge it before
6. A lways use the specified charger to charge the battery. When the
7. When you charge a new battery pack or a battery pack which has not been used for a long
period, it may not accept a full charge. This is a normal condition and does not indicate a
problem. You can recharge the battery pack fully after discharging it completely a couple of
times.
8. U nplug the charger from the power source after finish the charge.
9. Please remove the battery from the unplugged charger for storage.
The LED Light on the Charger
Power On (Green light flashes slowly)
Battery Low (Red light stays illuminated)
Battery charged 80% (Green light flashes rapidly)
Battery charged 100% (Green light stays illuminated)
Battery Pack temperature is too hot or too cold (Red light flashes slowly)
Battery Pack malfunction (Red and Green lights stay illuminated)
Battery Pack LED Indication Function (Optional)
The Battery Pack has a "SW" button and 4-step green LEDs for indicating remaining capacity
status. The fuel gauge green LED will indicate when the "SW" button is momentarily pressed.
battery pack.
pull the tool unit from the battery pack in the direction.
pack sliding groove and push the tool unit into place.
The tool unit can be slide into battery pack in two directions.
pack does not slide in easily, it is not being inserted correctly.
on the charger.
charger is "ON". The battery pack is now starting the charging cycle.
battery pack is now ready for use.
use.
battery pack is inserted into the charger correctly, the red light will
come on and charging will begin.
• 8 •