LG DLEX5780 E Series Owner's Manual page 52

52
TrOuBLESHOOTiNg
Before Calling For Service (cont.)
Problem
There are no • The function of this cycle is to
creases left on remove wrinkles from fabric.
garment after
Steam Fresh™
Garments have • This is normal.
static after
Reduce Static
Garments are • Correct drying options not
too damp or selected.
too dry after
Reduce Static
Garments are not • Number of garments or load
uniformly damp size not properly selected at the
after Easy Iron beginning of the cycle.
Water drips • This is normal.
from door
during Steam
Cycle
Steam is not • This is normal.
visible during
Steam Cycle
Drum does not • This is normal.
turn during
Steam Cycle
Cannot see • This is normal.
steam vapor at
the beginning
of cycle
The display • More Time button pressed.
shows
Odors remain • Steam Fresh™ did not remove
in clothing after odor completely.
Steam Fresh™
Clean Filter • Lint filter is almost clogged or
light is on full.
during the
drying cycle
TM
Flow Sense • Ductwork is too long or has too
indicator many turns/restrictions.
shows four
• Significant blockage of the
bars during the
ductwork due to lint buildup or
drying cycle
debris.
or the display
• The appliance has detected a
shows "d80"
restriction in the external dryer
after drying.
venting.
MFL67731040_en_170712.indd 52
Possible Causes
• Use an iron to make creases.
• Depends on individual moisture level in skin.
• Select load weight manually before starting Reduce Static
• Select the correct number or garments or load size before
• Condensation will normally form on the inside of the
• Steam vapor is difficult to see when the door is closed.
• The drum is turned off so that the steam vapor remains in
the drum. The drum will normally turn for about 2 seconds
once a minute.
• Steam is released at different stages of the cycle for each
• This display indicates that the steam option has been set
for a "
Press the Less Time button to reduce the indicated load
size.
• Fabrics containing strong odors should be washed in a
• Pause the drying cycle and clean the lint filter.
• Install a shorter or straighter duct run. See the Installation
• Ductwork should be checked/cleaned soon.
• If exhaust restrictions are sensed by the Flow Sense
Solutions
option.
starting the cycle.
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
However, condensation will normally form on the inside of
the dryer door if the steam system is operating normally.
option.
" item such as a comforter.
normal cycle.
Instructions.
Dryer can be used in this condition, but drying times may
be longer.
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
Power button will turn off the display.
TM
2017.7.12 5:19:6 PM