Table of Contents
Advertisement
IX. Replacement Parts
REPLACEMENT PARTS
1. 6 inch Casters – PCU800, PCU1000
2. 6 inch HD Casters -PCU2000
3. Plastic latch.
4. Metal door hinge
5. Clear plastic menu panel
6. Hot Module
7. Cold Module
The model number of the Cambro cart is required to determine the correct
replacement part. The cart model number can be found on the left side of the cart.
Each electrical item has a label marked with serial and model number. For all
electric and non- electric models that begin with the prefix PCU:
TO ORDER REPLACEMENT PARTS:
• Call Cambro Customer Service at 800 833 3003 or
• Call International 714 848 1555
• Fax your order to 714 842 3430 or
• Call your local Cambro Representative or Distributor
IX. Hitch Installation Instructions
REPLACEMENT PARTS
1. Place cart on it's side.
2. Line up Chassis Plates with molded-in steel threaded inserts.
3. Use Hex Head Bolt and a washer with each bolt. Tighten snug
(Do Not overtighten). Use removable thread-locker.
4. Attach Hitch Ball (if using) and Tow Bar.
5. Insert Locking or Non-Locking Pin to secure.
MUST have Swivel Casters
on Tow Bar end
Molded-in Steel
Threaded Inserts x8
Note:
These inserts MUST be
molded-into the body for
the Hitch accessory
Locking or non-locking Pin (2)
WARNING! Components and Cart, with installed Hitch are NOT intended for use on the STREET or HIGHWAY. Pulling speed should NOT exceed ten (10) miles per hour.
When the Tow Bar is not in service, it should be pinned in the vertical position or completely removed from the cart to reduce a trip hazard.
CAUTION! Careful attention is required while towing these carts. It is NOT recommended to connect more than six (6) carts together. Unplug power before moving and
confirm all doors are closed and latched.
Tow Bar
PCU or PCUL
3/8 Flat Washer x8
Hitch Ball Adapter
Chassis Plate and Receiver Bar
3/8 - 16 x 5/8 inch longHex Head bold x8
Note:
Tighten snug (Do Not Overtighten)
Use Removeable thread-locker
8
Advertisement
Table of Contents
