Table of Contents
Advertisement
IV. Operating Instructions for Electric Use (HOT)
Note:
Units are designed to hold pre-heated hot food and pre-chilled cold food only. ALWAYS pre-heat or pre-chill unit. NEVER use to heat up or cool down food temperatures.
WARNING! Not intended for use outdoors. NEVER use in wet or damp conditions. Refer to Section II for Safety Instructions and Warnings.
Hot Electric Model:
Hot Module
• PCU800HH, PCU800HC, PCU800CH, PCU800HP & PCU800PH
• PCU1000HH, PCU1000HC, PCU1000CH, PCU1000HP & PCU1000PH
• PCU2000HH, PCU2000HC, PCU2000CH, PCU2000HP & PCU2000PH
Operation:
Plug the power cord connector end into the Hot Module, then plug the other end into your power
source 100vac - 240vac, 50/60 Hz. The display screen will light up showing the home screen; touch
the word "Set" and a new screen will appear. This new screen will give you the option to choose F or
C degrees Unit of Measure and a horizontal slider to adjust your temperature set-point.
Once you have made your choices, touch the word "OK" and the screen will go back to the home
screen. touch the word "Start" on the GREEN field and the unit will start operating. Note; once the
unit starts operating, the screen will show the word "Stop" on a RED field. This RED "Stop" button,
if touched will end operation of the unit and return the button to a Green field with the word "Start".
The letter "i" in the top left corner; once touched, will provide a run time/temperature graph. Touch
the graph and the screen will return to the home screen.
Factory Set at 160°F (71°C)
Adjustable from 70°F (21°C) TO 185°F (85°C)
Heat up time to 165°F (73,9°C) approx. 15 minutes
IV. Operating Instructions for Electric Use
Cold Electric Model:
COLD Module
• PCU800CC, PCU800HC, PCU800CH, PCU800CP & PCU800PC
• PCU1000CC, PCU1000HC, PCU1000CH, PCU1000CP & PCU1000PC
• PCU2000CC, PCU2000HC, PCU2000CH, PCU2000CP & PCU2000PC
Operation:
Plug the power cord connector end into the Cold Module, then plug the other end into your power
source 100vac - 230vac, 50/60 Hz. Use the switch next to the connector to power the unit on and the
display will light up showing two numbers; the top number is the actual compartment temperature
and the bottom number is the Set point.
Setting the Temperature:
1. Press the SET button one time, the bottom number will now flash.
2. Press the SET button to increase the desired temperature / Press the C/F button to decrease the desired temperature.
3. Do not press any buttons for three (3) seconds and the temperature will be set.
How to set F or C units:
1. Press the C/F button to toggle between Celsius and Fahrenheit display.
Factory Set at 32.5°F (,28°C) / Adjustable from 32.5°F (,28°C) TO 70°F (21°C) / Cool down time to 32.5°F
(,28°C) approx. 90 minutes. MAX- Ambient room temperature must be no more than 90°F (32,2°C).
4
Advertisement
Table of Contents
