Asphalt Kingdom RY30MK Operation Manual

•

Operation Guide

Before beginning please check the following:

1. You have read and understand all warnings on page 2.

2. You are using new and full propane cylinder (use of a used cylinder can lead to reduced performance or

equipment failure).

3. You have inspected your regulator, hose, and torch assembly and verified there are no leaks or physical damage.

4. You are outdoors in a well-ventilated area that is free and clear of any flammable matter.

5. You have completed the assembly of the equipment correctly.

6. You have 'Direct Fire' type crack sealant such as GemSeal, SealMaster, Durafill, Craftco or Maxwell.

7. There is absolutely NO water in or around the kettle.

8. You are wearing a protective face shield.

9. You are wearing heat and fire-resistant protective gloves.

10. You are wearing heat and fire-resistant protective clothing which covers all exposed skin.

Part 1 – How to Load and Light your Melter

⚠ Inspect and ensure there are no leaks between any of the connections before proceeding.

1. Load crack sealant into kettle, while ensuring sealant is resting on the bottom of the kettle.

2. How to Light your Torch

Fully CLOSE the regulator valve by turning the

knob on the regulator COUNTERCLOCKWISE

Fully OPEN the propane cylinder by

turning the valve COUNTERCLOCKWISE.

Table of Contents

Need help?

Do you have a question about the RY30MK and is the answer not in the manual?

Page 1 • Operation Guide Before beginning please check the following: 1. You have read and understand all warnings on page 2. 2. You are using new and full propane cylinder (use of a used cylinder can lead to reduced performance or equipment failure).
Page 2 Remove the torch from the machine and turn the regulator knob two turns CLOCKWISE so that the propane starts to flow. Ignite the torch. Insert the torch to the torch holder.
Page 3 Adjust the flame by turning the knob on the regulator. ⚠ Never exceed the manufacturer's recommended material maximum temperature.
Page 4 • Operation Guide Part 2 – Agitating and Monitoring Temperature 1. Never leave melter unattended when the torch is lit. If the flame goes out, promptly turn off the flow of gas; double check that the melter is free and clear of any gas odors before lighting the torch again. 2.

Ry10mkRy30 pro