Page 1
Instruction Leaflet This product is intended for children able to sit unaided (minimum 6 months) and up to 36 months or a maximum weight of 15 kg. Chair mode: Complies with: BS EN 17191:2021. This product is intended for children able to sit unaided (minimum 6 months)and up to 36 months or a maximum weight of 15 kg.
Name of Parts Check all parts are present before assembly. Seat cover Insert tray Seat unit Seat base Main tray Short support tubes Footrest Long support tubes Support Support Name Tray Footrest Seat (short) tubes tubes (long)
Page 3
ASSEMBLY INSTRUCTIONS Assemble the Support Tubes Please note the letters on the seat base and the support tubes. Letter “A” : 2 short support tubes + 2 long support tubes Letter “B” : 2 short support tubes + 2 long support tubes Match the support tubes “A”...
Page 4
Assembling the Footrest Insert the footrest into the seat base,you should hear a “click”. Pull the footrest to make sure it is assembled in position. Press the pin behind the footrest and pull it out to disassemble. Adjust the Tray Positions Squeeze the two handles under the main tray at the same time to unlock and adjust the main tray in your desired positions.
Page 5
Harness & Buckle Instructions A B C D E Note: Thread the shoulder straps through the loops to reduce the shoulder strap height if required. To fasten the waist harness: Insert both buckle clips into each side of the buckle until a “Click!” is heard. To release the harness: Squeeze the buckles and pull apart.
Page 6
Highchair Mode Lo Chair Mode Remove the long support tubes and change it to Lo chair Mode. Toddler Chair Mode Remove the main tray and change it to toddler chair mode.
Page 7
Booster Seat Mode Remove the support tubes and change it to Booster Seat Mode. Fix the Booster Seat on the chair tightly with the belts under and behind the seat. WARNING! The two belts must be fastened tightly during use. Please fasten the belt with the loop when not in use.
Use of the Insert Tray The insert tray can be used with the main tray or on its own when at a table . General care The correct use and maintenance of this product is essential. Always ensure the product is stored in a dry place to prevent mould or mildew developing.
High / Lo Chair Mode Maintenance: Check that nothing is broken, torn or missing and that no sharp edges have been exposed. Stop using the highchair immediately if any are found. Inspect all studs, nuts and screws for tightness. Check that all straps and harness attachment points are in good working order.
Booster Mode Maintenance: Check that nothing is broken, torn or missing and that no sharp edges have been exposed. Stop using the booster seat immediately if any are found. Check that all straps and harness attachment points are in good working order. Always use the restraint system and the chair attachment system Always check the security and the stability of the chair mounted seat before use (when in Booster Seat mode).
Page 11
DO NOT place this product near a window where cords from blinds or curtains could strangle a child.i Complies with: BS EN 17191:2021. For all technical queries please call: 01454 326 568 Imported by: The Red Kite Baby Co Ltd. 35 Lavenham Road, Beeches Industrial Estate, Yate, Bristol, BS37 5QX. UK.
Need help?
Do you have a question about the Feed Me Snak and is the answer not in the manual?
Questions and answers