Advertisement
Installation
Charge for about 7 hours.
R When the batteries are fully charged, "Fully charged" is displayed.
Note:
R The handset display may show "Please wait for 1 minute." when the
handset is placed on the charger if it is not registered to the base unit.
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
charge again.
R To maximise battery life, it is recommended that the handset batteries be fully
discharged (used) until
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold MeN for
few seconds to turn the handset on.
1
Handset:
Lift the handset and press MeN.
2
Base unit:
Press and hold M
R Depending on the base unit, a registration tone sounds.
R If all registered handsets start ringing, press M
this step.
3
Handset:
Place the handset on the base unit or charger.
R Continue the operation even when the handset display shows "Please
wait for 1 minute.".
4
With the handset still on the base unit or charger, wait until a confirmation tone
sounds and
4
Rechargeable Ni-MH
ONLY
,
) and the charge contacts with a dry cloth and
flashes once every few months.
N for about 5 seconds.
is displayed.
Confirm "Charging"
is displayed.
N again to stop, then repeat
Advertisement
