Table of Contents
Advertisement
Central Remote Controller
3-2. How to Install
• Do not wire communication lines (control wiring between indoor and outdoor units, central control wiring) or input/output
wiring next to power supply wiring, etc., or house them in the same metal pipe. Doing so may result in failure.
• Install the central remote controller away from noise sources.
■
When installing to control board (control panel) or to a wall
The thickness of the board or wall must be 1.6 mm to 10 mm.
• Prepare the holes for installation beforehand, following the the diagram below (Panel cut dimensions diagram).
• Remove 1 panel fixing screw and open the panel.
• Attach the lower case with the four included fixing screws.
• Close the panel and attach it with 1 panel fixing screw.
14
-EN
Fixing screws
Panel
< Panel cut dimensions diagram >
CAUTION
Lower case
Panel fixing screw
100
50
50
W:95 × H:84
Square hole
47.5
47.5
95
Installation Manual
Control board or a wall
Screw holes (4 places)
Advertisement
Table of Contents
