Key Functions - Field Controls FC-60DH Quick Start Manual

KEY FUNCTIONS

KEY FUNCTIONS
1. Power Key
• Use this button to turn the dehumidifi er on and off .
• Press once to turn machine on. You will hear two beeps and the
green (solid or fl ashing depending on mode).
• Press the power button a second time and you will hear one beep as the machine shuts
down. Note that there is a 1 minute fan delay.
2. Arrow Buttons
• Use the up and down arrows to set the desired humidity setpoint on the display screen.
• The setpoint can be any number between 36%-90%. When the indoor humidity is higher
than the setpoint, the unit will operate.
* Keep in mind that the displayed humidity levels are approximate (+/-5%)
3. Continuous Mode
• To set the unit to run continuously regardless of humidity,
simply use the down arrow key to set the humidity below 36%.
• The continuous light will illuminate green and the display will show "CO".
• To switch back to normal humidistat operation, use the arrow keys to move the setpoint
above 36%.
4. Auxilary Terminals A5/A6
• The A5/A6 on the terminal strip can be used as a safety switch for an external fl oat switch or
condensate pump.
• It should be set to N/O (normally open) at the accessory fl oat switch.
• If an E4 error occurs immediately, switch the wiring to N/C (normally closed) on the external
device. Note that you may need to unplug the unit to reset the error code.
P/N 780107800 09/21 RevA
Page 4 of 12
light will illuminate