Advertisement
Figure
3.
Mechanical counter installed in breaker.
9.
Reinstall the breaker top cover, ensuring that the
Trip Unit and
properly aligned with the cover. Tighten the four
#10-32
screws to
10.
Replace the trim plate and tighten the four
20
screws to
in-lbs.
11.
If it is a draw-out breaker, rack it back in.
__
The
Mechanical Counter does
not advance with operation of
the breaker.
The first digit of the
Mechanical Counter is partially
obscured in the top cover
window, as in Figure
These instructions do not cover all details or variations in equipment nor do they provide for every possible
contingency that may be met in connection with installation, operation, or maintenance. Should further
information be desired or should particular problems arise that are not covered sufficiently for the
purchaser's purposes, the matter should be referred to the GE Company.
GEH-62808 0296
aluminum
accessory sleeve are
32
in-lbs.
Possible Cause
The spring-loaded Mechanical
Counter arm is not above the tab on
the ON-OFF flag.
The Mechanical Counter is out of
adjustment on the mounting plate.
4.
General Electric Company
41 Woodford Ave., Plainville, CT 06062
© 1996 General Electric Company
12.,
Apply control power
follow the normal procedure
springs and tum the breaker on.
Trouble-Shooting
The following guide is provided for trouble-shooting
and isolating common problems. It does not cover every
possible situation. Contact the ED&C Customer Support
800-843-3742
Center at
these procedures.
Partially Obscure Counter Display
#8-32
4.
Figure
Counter partially obscured in top cover window.
Corrective Action
See step
Measure the interference. Remove the
breaker top cover and the Mechanical
Counter assembly. Loosen the two screws
holding the Counter to the mounting
plate. Slide the Counter over by the
amount of the interference. Tighten the
two Counter mounting screws to
then reinstall the Counter as per the
installation instructions.
GE Electrical Distribution & Control
to
the
accessories,
to
recharge
if any problem is not resolved by
6
of the installation instructions.
10
then
the
in-lbs,
Advertisement
