Advertisement
Technical data
Power
Statement of conformity
Group, category, type of protection,
temperature class
Electrical isolation
Input/Output
Input/power supply
Directive conformity
Directive 94/9/EC
General information
Supplementary information
Configuration
Switches 1 ... 4
Potentiometer 1 ... 4
The front-mounted potentiometers are used for fine adjustment of current transfer. The factory-setting of the device is calibrated
to the function transmitter power supply. If using the device as current driver, the Offset of the output stage can calibrated via the
potentiometers.
Configure the device in the following way:
• Push the red Quick Lok Bars on each side of the device in the upper position.
• Remove the device from Termination Board.
• Set the DIP switches according to the figure.
The pins for this device are trimmed to polarize it according to its safety parameter. Do not change!
For further information see system description.
Additional information
The device operates as a SMART transmitter power supply or as a repeater:
• As a SMART transmitter power supply, it provides a fully floating supply to power up to four 2-wire transmitters in a hazardous
area, repeating the current to drive a safe area source or sink mode output.
• As a repeater, it transmits a 4 mA ... 20 mA input signal from a control system to drive HART I/P converters, valve actuators,
and displays in a hazardous area.
Refer to "General Notes Relating to Pepperl+Fuchs Product Information".
Pepperl+Fuchs Group
USA: +1 330 486 0002
www.pepperl-fuchs.com
pa-info@us.pepperl-fuchs.com
P
586 mW
o
PF 11 CERT 2109 X , observe statement of conformity
¬ II 3G Ex nA IIC T4 Gc
safe electrical isolation acc. to EN 60079-11: 2007, voltage peak value 375 V
safe electrical isolation acc. to EN 60079-11: 2007, voltage peak value 375 V
EN 60079-0:2009, EN 60079-11:2007, EN60079-15:2005 , EN 60079-26:2007 , EN 61241-11:2006
EC-Type Examination Certificate, Statement of Conformity, Declaration of Conformity, Attestation of
Conformity and instructions have to be observed where applicable. For information see www.pepperl-
fuchs.com.
CH 1
CH 2
4
1
ON
FUNCTION
for
EACH CHANNEL
Analog input with
source output 4-20mA
Analog input with
source output 1-5V
Analog input with
sink output 4-20mA
Analog output
Germany: +49 621 776 2222
pa-info@de.pepperl-fuchs.com
CH 3
CH 4
4
4
4
1
1
1
ON
ON
ON
SWITCH SETTINGS
1
2
3
4
OFF
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
CAUTION
Refer to the instruction
manual to install and
operate the unit
Singapore: +65 6779 9091
pa-info@sg.pepperl-fuchs.com
HiD2024
3
Advertisement
