Introduction Congratulations and thank you for purchasing Beale Basics Series speakers from Beale Street Audio! Beale Basics On-Wall/Pendant speaker installs with ease using the provided pendant or wall mount hardware. Please follow the instructions in this manual to assure proper installation and to achieve the full performance and satisfaction you would expect from Beale Street Audio.
Installation Choose a location for each speaker that can support the weight of the speaker. 1. At each speaker location, route the speaker cable hanging from the ceiling through the top cover and dress the cables to the wire rope. Using the provided back cover, slide the speaker cables through the hole in the back cover 2.
Page 5
HANGING NOTE: Make sure the speaker is properly secured to the building’s structure. Please use the proper screws, bolts, or anchors as failure to do so may cause the speaker to become unsecured and cause potential damages and injuries. WALL MOUNT NOTE: When mounting the speaker to the wall or ceiling, make sure the proper screws and/ or bolts are used.
Page 6
70/100V Configuration The total number of speakers multiplied by the tap value cannot exceed the output power (in watts) of the 70V/100V amplifier. The example above shows 5 total speakers. Using the 10W taps, you will need an amplifier with at least 50W (5 speakers x 10W tap). A good rule of thumb is to select an amplifier with 20% greater power;...
(US only) a replacement speaker or your repaired speaker. If a current model is substituted for your speaker, a modification to the mounting surface may be required. Vanco is not responsible or liable to make, account for or pay the cost of any such modification.
Page 8
The Vanco logo, Sonic Vortex logo, and Beale Street Audio Inc. logo are registered trademarks of Vanco International, LLC. Vanco, Sonic Vortex, Beale Street Audio, Get Reale. Get Beale., the Vortex logo, and the Beale Street Audio logo are trademarks of Vanco International, LLC.