Summary of Contents for KEMKRAFT KEI-850A
- Page 1 KEMKRAFT ENGINEERING, INC. MODEL KEI-850A READOUT BOX INSTRUCTION MANUAL CLEAR VISION DUAL INCLINOMETER BOX MODEL # KEI-850A GM TRUCK & BUS REVISION DATE: 25-MAY-00 96-036.doc 47650 Clipper Dr. Plymouth Twp., MICHIGAN 48170 (734)-414-6500...
- Page 2 A) Apply power to the KEI-850A by turning on the power switch located on the bottom left part of the enclosure. This power switch also doubles as a circuit breaker for the KEI-850A Display box.
- Page 3 If this is the case, send the unit back to Kemkraft for modification. The Hex value is displayed to observe when the number settles out after the cal stand has been moved to a new position.
- Page 4 KEMKRAFT ENGINEERING, INC. MODEL KEI-850A READOUT BOX After the switch is pressed, the display will instruct you to place the cal stand to the -45 degree, than to -30 degrees etc. until +60 degrees is completed. When the cal stand is placed in the +60 degree position and the CALIBRATE switch is pressed, the program will go back to RUN mode and the calibration procedure for that tool is finished.
-
Page 5: Computer Interface
* WARRANTY AND SERVICE INSTRUCTIONS * Kemkraft Engineering, Inc. warranties this equipment against defects in workmanship and materials for a period of 90 days from date of shipment. We will, at our option, repair or replace products which prove defective during the warranty period. No other warranty, expressed or implied, is given.