Advertisement

Quick Links

WESTLAB
FXP12M
OPERATING MANUAL
TABLE OF
CONTENT
*Please read this instructions
carefully before use.
1800 358 101
1
1
1
1
2
2
3
3
3
4
4
4
5
5
1300 725 903
sales@westlab.com.au
www.westlab.com.au

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FXP12M and is the answer not in the manual?

Questions and answers

Summary of Contents for Westlab FXP12M

  • Page 1: Table Of Contents

    WESTLAB FXP12M OPERATING MANUAL TABLE OF CONTENT 1. Applications 2. Specifications 3. Construction 4. Approvals 5. Guidelines 6. Do/ Don’t 8. General Cleaning 9. Installation 10. Operation 11. Tank Heating 12. Servicing 13. Performance Test 14. Warranty Statement 15. Warning *Please read this instructions carefully before use.
  • Page 2: Applications

    WESTLAB 1. APPLICATIONS FXP12M The FXP range is a single chamber device used to clean OPERATING instruments and other hardware with ultrasonic energy in a mixed water/chemical solution. MANUAL 2. SPECIFICATIONS Model FXP12M Timer Mechanical (30min) Heating Power Tank Material...
  • Page 3: Guidelines

    WESTLAB 5. GUIDELINES FXP12M Always allow 5 minutes for fresh liquids to degas. • OPERATING Degassing is the action of removing air bubbles from the • solution, which is achieved from turning the ultrasonics on. MANUAL It is not recommended to operate unit for longer •...
  • Page 4: General Cleaning

    WESTLAB 8. GENERAL CLEANING: FXP12M The turnover of solution must be determined by the user • OPERATING to satisfy acceptable cleaning results of the finished article. If the contamination is heavy and difficult to remove, • MANUAL a pre-rinse in a heated solution could be enough to soften and loosen unwanted debris for ultrasonic cleaning.
  • Page 5: 11. Tank Heating

    WESTLAB 11. TANK HEATING FXP12M FXP12M heated ultrasonic cleaner models use silicon rubber OPERATING contact heaters on the outside face of the tank and are thermostatically controlled. The liquid level in all cleaners MANUAL should not drop below 80mm from the tank bottom and the thermostat setting should not exceed 60°C.
  • Page 6: 14. Warranty Statement

    WESTLAB 14. WARRANTY STATEMENT: FXP12M The MANUFACTURER of this machine, WESTLAB OPERATING AUSTRALIA PTY. LTD., warrants it to be free from defects in material and workmanship under normal use MANUAL and service and the purchaser shall be entitled to the following consideration:...

Table of Contents