Advertisement
Quick Links
Advertisement
Related Manuals for Gradus Group GABOR FPS-M
Summary of Contents for Gradus Group GABOR FPS-M
- Page 1 FPS-M / MODERN EASEL DISPLAY STAND User Manual for Medium Flat-Panel Displays...
- Page 2 Thank you for choosing Gabor. The Gabor Modern Easel Display Stand is a stylish way to support your display in any apartment, office, home theater, or trade show. The stand’s smooth wooden and metal finish will elegantly display flat-panel monitors from 40 to 60 inches, and up to 70 pounds. Your screen will sit at an optimal viewing height on three stable wooden legs, and the cable management will keep your setup looking clean, without cords everywhere.
-
Page 3: Safety Warnings
Safety Warnings • Please read and follow the instructions, and keep this manual in a safe place. • Always use the included security cable system when installing this product. • To avoid damage to this product, be careful not to overtighten or improperly •... -
Page 4: Product Specifications
Product Specifications Recommended Screen Sizes VESA Mounting Patterns 40 to 60 in. (101.6 to 152.4 cm) 200×200 mm 300×200 mm Ø35mm 300×300 mm Dimensions 400×200 mm Height: 54.25 in. (137.8 cm) 400×300 mm Riser Height: 23.75 in. (60.3 cm) 400×400 mm Width: 35.5 in. - Page 5 Overview Required Tools Drill Phillips screwdriver Riser Cable clip screw Cable clip 4 mm hex wrench M5 × 14 mm screws M6 × 14 mm screws Hammer Front leg Stud finder M6 × 30 mm screws M8 × 30 mm screws M8 ×...
- Page 6 Assembling the Easel Stand Important! Secure the locking collar before attaching the display. Make sure the screws face towards the rear. Recommended distance: 2 to 6 in. (50 to 150 mm)
- Page 7 Attaching the Display/TV Brackets If Your Display Has Recessed Mounting or a Curved Back, install the spacers between the bracket and your display. Warning T O P If the screw is too short, it may not hold the display. If it’s too long, it may damage the display.
- Page 8 Mounting the Display On the Easel Stand Important! We recommend that Note: Make sure the display is not resting directly on the riser. two people perform this step. Step 1...
- Page 9 Attaching the Security Clamps to Wooden Studs It’s important to use the security cable system for additional protection against tipping over caused by accidental bumping or movement of the easel and your display. Use the four anchor screws to attach the Caution: Wooden studs run vertically inside the wall.
- Page 10 Attaching the Security Clamps to a Concrete Wall or Concrete Blocks Caution! Make sure the concrete wall or block is solid and at least 8 inches (20 cm) It’s important to use the security cable system for additional protection thick. Install the security clamps at least 16 inches apart. If the concrete exhibits against tipping over caused by accidental bumping or moving of the cracks or other defects, this may result in failure of the wall anchors and cause easel and your display.
- Page 11 Attaching the Attaching the Cable Security Cable Management Clips...
- Page 12 For more information or to arrange service, visit www.madebygabor.com or call Customer Service at 212-594-2353. Product warranty provided by the Gradus Group. www.gradusgroup.com Gabor is a registered trademark of the Gradus Group. © 2021 Gradus Group LLC. All Rights Reserved.
Need help?
Do you have a question about the GABOR FPS-M and is the answer not in the manual?
Questions and answers