Related Manuals for Outland Technology FMPPC2-2
Summary of Contents for Outland Technology FMPPC2-2
- Page 1 Owner’s Manual Model number FMPPC2-2 Series number 823 D.823.000.V3 FMI BRANDS INC. 107 – 19052 26 Avenue | Surrey, B.C. Canada V3Z 3V7 | Toll Free 1-888-514-1663 | Fax 1-888-797-9931...
- Page 2 Owner & Safety Manual Model number FMPPC2-2, Series Number 823 - Tested by CSA International DANGER: If you smell gas: 1 Shut off gas to the appliance. 2 Extinguish any open flame. 3 If odour continues, keep away from the appliance and immediately call your gas supplier or fire department.
- Page 3 Disconnected cylinders must have threaded valve plugs tightly WARNING: installed and must not be stored in a building, garage or any other enclosed area. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read The gas pressure regulator provided with this appliance must be the installation, operating and maintenance instructions used, and must be the same model as supplied with the unit.
- Page 4 Owner & Safety Manual All LP cylinders to be used with this appliance must be: WARNING: a. Constructed and marked in accordance with the specifications for LP-gas cylinders Standard, Ensure that the LP gas cylinder is kept at a minimum CAN/CSA B339, Cylinders, Spheres and Tubes for the distance of three feet (36 inches) away from the appliance.
- Page 5 LEAK TEST: Keep the appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids. 1. DO NOT USE OR PERMIT SOURCES OF IGNITION IN THE AREA WHILE DOING THE LEAK TEST. Solid fuels shall not be burned in this appliance. THIS INCLUDES SMOKING.
- Page 6 Owner & Safety Manual SECTION 1: ASSEMBLY SECTION 2: IGNITION STEP 1 STEP 1 Enclosed are four bags of rocks, one factory installed 10' Ensure that unit valve dial is in the propane-rated hose with attached regulator, and one propane tank “OFF”...
- Page 7 SECTION 2: IGNITION (continued) STEP 6 STEP 7 Using a lighter or match, ignite Once the unit is burning normally lighter and hold flame slightly set the dial to desired flame above the burner, then open the height. valve on the appliance slowly by turning (counter-clockwise) until the unit ignites.
- Page 8 Owner & Safety Manual SECTION 4: EXTINGUISHING THE APPLIANCE STEP 1 STEP 2 STEP 3 Turn cylinder valve to the “Closed” position. Turn appliance valve to the “Off” position Allow unit to cool for at least five by pushing and turning knob clockwise. (5) minutes before relighting.
Need help?
Do you have a question about the FMPPC2-2 and is the answer not in the manual?
Questions and answers