Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for WARDRAY PREMISE XRT4500
Summary of Contents for WARDRAY PREMISE XRT4500
- Page 1 GEN.S.19/237 OCTOBER 2019 XRT4500 Folding Portering Chair OPERATORS MANUAL...
- Page 2 Introduction Thank you for purchasing this X-ray product. Manufactured and tested to the highest standards. Our products are manufactured by Wardray Premise Ltd at our UK based factory to BS EN ISO 13485:2016 and are CE marked. To ensure that you obtain maximum benefit from your product, please take a few minutes to read the enclosed information regarding operation, service and maintenance.
-
Page 3: Specification
Specification The XRT4500 folding portering chair is designed to be used in an X-ray environment, and is manufactured and tested to the highest standards. The XRT4500 is constructed from 2 main materials, these being aluminium, and 316 stainless steel. The main frame is manufactured from aluminium which is lightweight, this aids the easy movement of the chair. - Page 4 XRT4500 Portering chair parts reference In folded position Push handles Backrest Adjustable armrest Rear Brake Seat Serial No. Rear Wheel located on upright Plungers Threaded Lobe Knob Front Brake Footrests Castor...
- Page 5 Operating Instructions Armrest Armrests have been fitted to both sides of the chair these are to aide comfort whilst the patient is sat in the chair. The armrests should be in the lowered position when the patient is getting in and out of the portering chair.
- Page 6 Operating Instructions Footrests Designed for patient comfort and ease of use the footrests can be removed completely (Fig 3) if not required. To remove the footrests, loosen the threaded lobe knob on the front side of the chair (Fig 4) by unscrewing in a counter clockwise direction.
-
Page 7: Braking System
Operating Instructions Braking System The folding portering chair is fitted with two 150mm diameter, individually braked castors on the front of the chair (Fig 1) and a rear brake is also fitted to the right hand wheel (Fig 3) . To engage the brakes on the front castors place your foot on the front part of the brake lever (Fig 1) and push down firmly, the brake will lock in place and stop the castor from moving. - Page 8 Operating Instructions Folded Position To place the chair into the folded position rotate the footrests into an upright position (Fig 1) and simply lift the seat. The chair will assume the folded position (Fig 2). There is no locking mechanism, the weight of the chair keeps it in the folded position. To open the chair, from its folded position, stand behind the chair and widen the push handles apart.
- Page 9 ‘tipped out’. The chair should be serviced regularly, but only by Wardray Premise trained engineers, as they will carry the correct spares to guarantee the continued safety of the chair. Failure to...
-
Page 10: Do's And Don'ts
There are no known types of approved tie down systems for safe transportation of a user in a portering chair, in a moving vehicle of any type. The XRT4500 portering chair is intended for the assisted movement of a non ambulatory ... - Page 11 Do’s and Don’ts Don't: attempt to pull the portering chair with a patient in. It must be pushed at all times. operate the portering chair on roads, streets or highways. use to go up or down inclines of greater than 9 degrees. ...
-
Page 12: General Maintenance
Check operation of footrest including possible damage to heel straps. Do not attempt to rectify any faults on the chair without contacting Wardray Premise. There is no Service Manual available for this product. Please register your product with us, via the Warranty Registration Form (see page 15), for ease of contact in case of urgent upgrades or recalls. -
Page 13: Eu Declarations Of Conformity
If required the product can be washed down with hand hot sodium hypochlorite solution up to 1% or 10000 parts per million chlorine combined with a detergent. Alternatively, follow your local guidelines or instructions. If any of the above give cause for concern, please contact your Wardray Premise service provider. EU Declarations of Conformity...