ulsonix USX-ST5 User Manual page 35

1. Fill the tank with water. To do this, unscrew the cap (4), place a funnel
(16) in the opening and, using the measure (17), measure the desired
amount of water. Pour in the water, remove the funnel from the
opening and screw the cap on.
2. Connect the steam hose and preferred operating nozzle according to
the instructions in the Assembly of the unit section.
3. Connect unit to power source, then turn on by setting the On/Off
button to the "I" position. The indicator light (A) on the display will
light up.
4. Press the button (8) on the casing to start the steam generation
process.
The indicator (C) will light up. When the device is above 4 bar and
ready for operation, indicator (F) will light up.
5. Control the steam output with the steam gun at the end of the steam
hose.
I.e. using the switch (c) select the steam output level (1-min/2-max),
for the selected level the corresponding indicator (G/H) will light up.
When both lights are on, the maximum steam output level is reached.
The machine will eject steam while the trigger is depressed.
6. Child lock - when the trigger is not depressed, sliding the lock provides
protection against starting the device. When the trigger is depressed,
sliding the lock will lock the position, steam will be released
continuously.
7. When the indicator light (B) appears in the display, the steamer has
either overheated (in this case, stop using the steamer and allow it to
cool down) or it is upside down (correct the position).