Specification - Lanberg RS Series Quick Installation Manual

Quick Installation Guide
Rack type PoE+ switches
1.4)

Specification

Performance
Input voltage
Input frequency
Input current
PoE budget
Max. PoE per port
MAC address table
2) The importance of individual elements
Functions
2.1) LEDs and their meaning
Lanberg's rack type PoE switch, has, on the front panel, multiple LEDs. Their number and meaning may
vary depending on your model. The below-displayed table contains an explanation of each LED regardless
of the rack switch model.
LED
Power
1 – 24
25 – 26
The front of the switch housing lists separately the LEDs indicating Ethernet connection status - the section
in the box labeled with the signature „LINK / ACT", and PoE status – the LEDs located under the ports. The
colors mentioned in the table above do not refer to individual LEDs, but only treat them in general terms.
E-mail: support@lanberg.eu
www.lanberg.eu
Value
100 ~ 240 V
50 / 60 Hz
max. 5 A
360 W
30 W (af + at)
16 K
Link & PoE 250 m (@ max. 10 Mb/s) with VLAN; VLAN; disabling PoE ports
from the largest to the smallest (by numbering) after exceeding the PoE
Meaning
Power
Port
(LAN / Ethernet
with PoE+)
Port
(LAN / Ethernet /
SFP)
Lanberg © 2015-2021
Performance
Switch voltage
Switch frequency
Switch current
Max. power consumption
PoE ports
Uplink ports
budget
Solid LED
Device is turned
on
Green color:
Device is
connected
Orange color:
Device with PoE
mode is
connected
Device is
connected
24x 100 Mb/s
2x 1000 Mb/s
Blinking LED LED is turned off
Device is turned
-
Green color:
Data
transmission /
occurred with
reception is in
progress
transmission or a
device without
Data
transmission /
reception is in
progress
Value
55 V
50 / 60 Hz
0.6 A
380 W
(LAN: 1 ~ 24)
(LAN 25 ~ 26)
off
Green color:
Device is not
connected
Orange color:
An error has
PoE power
PoE has been
connected
Device is not
connected
PL | EN
10 | 14