Pip Assembly Removal - JBL A6000GTi Service Manual

137159-1 Rev. 1
4.3.4.

Pip Assembly Removal

1. Using a T-15 screwdriver, remove the five Torx-head screws from the bottom of the
amplifier holding the plastic pip holder to the chassis.
2. Disconnect the two ribbon cables from the pip board. Both of these cable connectors
have latches.
3. Remove PIP Assembly (see Figure 4.7).
Figure 4.7 Input PIP and Input Housing Assembly Removal.
2003 Crown Audio, Inc.
A6000GTi Service Manual
PIP
Assembly
Maintenance 4-6