XPOtool 62856 Operation Manual

Beam clamp

Operation Manual

Beam Clamp

62856

Illustration similar, may vary depending on model

Read and follow the operating instructions and safety information before using for the first time.

Technical changes reserved!

Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.

Updating the documentation

If you have suggestions for improvement or have found any irregularities, please contact us.

Table of Contents

Need help?

Do you have a question about the 62856 and is the answer not in the manual?

Page 1 Operation Manual Beam Clamp 62856 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
Page 2 Returns Department WilTec Wildanger Technik GmbH Königsbenden 28 52249 Eschweiler E-mail: service@wiltec.info Tel: +49 2403 55592–0 Fax: +49 2403 55592–15 https://www.XPOtool.com Item 62856 Page 2 The Tool Experts 2022-1...
Page 3 4. Check the beam and make sure that the clamp jaws adequately clasp the flanges of the beam. 5. Ensure that the hoist or sling that is going to be attached to shackle of the beam clamp is located directly beneath the clamp. https://www.XPOtool.com Item 62856 Page 3 The Tool Experts 2022-1...
Page 4 Lever Beam Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction manual require the written permission of WilTec Wildanger Technik GmbH. https://www.XPOtool.com Item 62856 Page 4 The Tool Experts 2022-1...