Operation Of The 500A1 Moisture Sensor Kit; Introduction And Requirements - HARVEST 500A1 Operation Manual

OPERATION OF 500A1 MOISTURE SENSOR KIT

Introduction and Requirements

Thank you for purchasing a 500A1 Moisture Sensor Kit and congratulations. The 500A1 Moisture
Sensor Kit is designed to work with any AGCO 2150-2190 or Challenger LB33B-LB44B large square
balers Model Year 2008 and newer. If you do not have the AGCO Bale Chute Scale option you will
need the parts listed below:
AGCO part numbers:
700733748 Square Baler Module (SBM)
700733750 Wire Harness (only needed on 2008-2011 Balers)
The Square Baler Module (SBM) and the Square Baler Controller (SBC) must run on version 3.0 or
higher. Please consult the Baler Operation Manual for more information.
For instructions on How to Mount the 500A1 to the Baler please refer to the 500A1 Installation
Manual.
5