Table of Contents
Advertisement
Multi-Storage Bay - Peripheral Placement (Continued)
To use the chassis top to set a
peripheral device, do the following:
1 Remove the bay cover (see step 1
on previous page).
2 Grasp the tab and pull it out
toward the front of the chassis
(figure E). Put the tab in its storage
area in the bay near the spindle
(figure F).
3 Thread the data and power
cables for the device through the
cable tunnel opening at the back
of the bay. Place the cables in the
tab opening and replace the bay
cover. Close the cover.
4 Connect the cables to the device,
and place it on the top of the
chassis (figure G). At the back of
the PC, connect the data cable to
the USB or FireWire connector on
the back of the PC. Plug the
power cord into a power outlet.
xii
HP Pavilion home PC
E
F
G
Advertisement
Table of Contents
