Page 1
Instruction & Parts Manual No 695 WGC No: 93.002.03 BT LOPPER 350...
Page 2
Tree - loppe r I I nstruction & parts manual TL150 TL250 TL350 For your safety: Always read this instruction manual before use...
Page 3
TURNER MACHINES, CHANGES IN SPECIFICATION ARE INEVITABLE. SHOULD YOU FIND THE INFORMATION GIVEN IN THIS BOOK TO BE AT VARIANCE WITH THE MACHINE IN YOUR POSSESSION, YOU ARE ADVISED TO CONTACT THE BOMFORD TURNER SERVICE DEPARTMENT WHERE UP-TO-DATE INFORMATION WILL BE PROVIDED.
Page 4
Improper use of this attachment may result in serious injury or death. If this manual is lost or damaged, please contact Bomford Turner Ltd immediately to obtain a replacement.
Page 5
Symbols The Following is a list of the symbols and the respective meanings used throughout this manual:- Δ DANGER DANGER indicates an imminently hazardous situation which, if not avoided, will result in serious injury or death. Δ WARNING WARNING indicates a potentially hazardous situation which, if not avoided, could result in serious injury or death.
Page 7
Introduction The manufacturing company guarantees its products to be free from defective material or faulty manufacture for a period of twelve months from the date of purchase. This warranty covers for labour costs and repair or replacement of any parts which, under normal use & service within the twelve month period stated above, and which, after subsequent examination by the manufacturer’s technical staff, disclose defective material or faulty manufacture.
WARNING Incorrect installation can be dangerous for the operator and may cause serious damage to the attachment and the carrier machine. If you are unsure about the correct method of installation, contact your dealer or Bomford Turner Ltd. Δ WARNING Before any installation, maintenance or repair work is carried out on this attachment ensure that the carrier machine is switched off at the ignition and the key removed, and that the hydraulic system is fully decompressed.
Tree-Lopper and any imposed loads in all positions, particularly when at full reach. Consult the operator’s/workshop manual for your excavator. Table A Model Weight Hydraulic Cutting capacity pressure (Softwood) TL150 190Kgs 210 Bar 200mm TL250 325Kgs 210 Bar 300mm TL350...
Page 12
Operate the bucket crowd control slowly whilst checking that there is no resistance or interference to movement. If there is any sign of a problem with the smooth functioning of the Tree-Lopper contact Bomford Turner Ltd. DO NOT attempt to carry out any modifications to the Tree-Lopper.
Page 13
Installation (contd.) wrapped to the existing hoses along the boom of the excavator to the cab. The switch can then be fitted to the joystick using tie-wraps for convenient operation. The fitted plug should be inserted in the excavator’s cigar lighter socket to provide a power supply. Δ...
Operation Δ WARNING The operation of this equipment must be carried out by competent, suitably trained personnel, experienced in the use of hydraulic excavators. Before using this equipment, the operator should read and fully understand this manual. Operators should be equipped with suitable safety wear and personal protection equipment as deemed to be necessary as a result of conducting the required risk assessment.
Operation (contd.) The Tree-lopper is manufactured to cut trees and wood only. Do not use the Tree-lopper to pull stumps out. Do not use the Tree-lopper for bulldozing or rooting. Do not bear the weight of the excavator on the Tree-lopper. ...