Table of Contents
Advertisement
Description of Labour TENS Unit &
Functions.
Channel A
Remote Channel B
NeuroTrac™
Labour TENS
Front
1.
Insert a 9 volt PP3 Alkaline battery. Alternatively insert a rechargeable
Nickel Hydride battery [Which has a much longer life than the Ni-Cad
rechargeable batteries] into the battery compartment.
2.
Insert lead wire/s to channel A and B if both channels are to be used.
3.
Insert Remote hand switch to centre connector as shown on page 8.
4.
Switch on the unit by pressing the ON/OFF button
5.
Press the remote hand switch to initially select Boost mode (BT)
6.
To start press channel A + and B + button if you are using
both channels.
7.
Increase the intensity using channel A+ or B+ until you feel a slight
muscle contraction, then press the button on the remote hand switch to
revert back to the rest mode (RT).
8.
When you feel labour pain, press the button on the remote hand switch
which will select Boost mode. When switching from Boost to Rest
mode the intensity will reduce by 20%.
9.
To decrease the intensity, select boost mode and press the channel A-
or B- button.
10.
Familiarise yourself with the unit before using it during labour
11.
To stop the programme, press the ON/OFF button which will turn the
unit off.
NeuroTrac™ Labour TENS Operation Manual
Remote Hand Switch
CH.B
LCD
Display
Increase
Intensity
Decrease
Intensity
7
Button
CH.A
Rear
Advertisement
Table of Contents
