BRACKENHEATH BR1191 Instructions

Remote 3 Hour Emergency Pack
Features
•
Plug and play conversion kit for 3 hour maintained emergency
back-up for square and circular LED panels
•
Integrated colour changing LED to indicate charging status
•
Built in overcharge, over-discharge, and short circuit protection
•
Preprogramed for monthly and annual self-testing
•
Test button for manual testing
•
High temperature Nickel Cadmium batteries
Safety Instructions
1. These instructions should be read carefully and retained after installation for future reference and maintenance.
2. Ensure that the mains power is switched off before carrying out installation or maintenance.
3. It is recommended that installation is carried out by a qualified electrician ensuring the installation complies with the current edition
of IET wiring regulations - BS 7671.
Environmental Instructions
This product may contain substances that can be hazardous to the environment if not disposed of properly. Electrical and electronic
equipment should never be disposed of with general household waste but must be separated for its correct treatment and recovery. Where
possible recycle your packaging.
Installation Instructions
•
Ensure the mains power is isolated
•
Connect LED load and LED driver to the
emergency pack, see diagram on right.
For further wiring details, see typical
conversion wiring diagram section
•
Switch on the unswitched supply and
check the charge indicator is on
•
Switch on the switched supply and
check the LED Load is illuminating
•
Switch off unswitched supply and check
the LED load has switched to emergency
mode with reduced light output
•
Switch on the unswitched Supply to
restore LED load to full brightness
Typical Maintained Emergency Wiring Diagram
BR1191 Remote 3 Hour Emergency Pack
200mm 33mm