Jeep 2022 WRANGLER RUBICON 392 Manual page 28

26 SERVICING AND MAINTENANCE
NOTE:
The captured fasteners are made to stay with the
first water separation chamber and must NOT be
removed.
2. Pull on the hood duct at the top to disengage
the push pin clip along with the rubber
grommet and remove from vehicle.
First Water Chamber Removal
Installation
NOTE:
Inspect and clean the housing if dirt or debris is
present before replacing.
1. Locate the first water separation chamber to
hood/second chamber then engage the push
pin clip and grommet.
First Water Separation Chamber
1 — Push Pin
2 — Grommet (On The Backside)
NOTE:
Both components should click-in. The cone shaped
of the second chamber can aid in locating parts.
2. Hand start the six captured fasteners.
3. Tighten the captured fasteners, do not
over-tighten.
Engine Air Cleaner Filter Inspection and
Replacement
Follow the recommended maintenance intervals
as shown in the Maintenance Plan in this section.