LENCO DIR-261 User Manual page 29

3. In System settings menu, if Language is selected, select one to set the interface
language.
4. In System settings menu, if Factory Reset is selected, set it to "YES" to proceed, set it to
"NO" to cancel factory reset.
5. In System settings menu, if Setup wizard is selected, you can confirm if start setup now.
6. In System settings menu, if Info is selected, you can check the "SW version", "Radio ID"
and "Friendly Name".
7. In System settings menu, if Backlight is selected, the screen will appear as attached
images.
If Timeout is selected, you can set the backlight of the screen of Timeout to On, 10 sec,
20 sec, 30 sec, 45 sec, 60 sec. 90 sec, 120 sec or 180 sec.
If On level is selected, you can set the backlight of the screen of Power On level to High,
Medium or Low.
If Dim level is selected, you can also set the backlight of the screen of Standby Level to
High, Medium or Low.
Error messages
Message
Failed to connect
Format error
Network error
Network not ready
Network timeout
Description
Correct key entered, but router
rejects request
Cannot recognize file format –
independent of network
Problem past router - incorrect data
being received from network
Problem with connection to router
Problem past router - no response
being received from network
29
Example
MAC filtering enabled on
router
Received MP3, but found that
the stream wasn't MP3 when
trying to decode
Data obtained from server is
unreadable.
Router switched off
Streaming IR station and
suddenly station becomes
unavailable