Advertisement

Rossi Field Stripping
Rossi Model 92 Disassembly -
1. Unscrew the tang screw and
remove the butt stock.
2. Pull back the hammer until the
small hole in the main spring rod is
visible in the 'V' of the main spring
rod block. Insert a small nail or pin
into the hole to keep the main
spring from flying off.
3. Remove the bolt pin stop screw.
4. Drive out the bolt pin from the
right side using small punch. It only
comes out right to left. and it only
goes back in the reverse order
http://www.leverguns.com/articles/taylor/field_strip.htm
select an image for a larger view

Screw Nomenclature and Location

Click Here for an exploded view of the Rossi 92
Seite 1 von 4
02.03.2011

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 92 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Rossi 92

  • Page 1 Rossi Model 92 Disassembly - select an image for a larger view Screw Nomenclature and Location Click Here for an exploded view of the Rossi 92 1. Unscrew the tang screw and remove the butt stock. 2. Pull back the hammer until the...
  • Page 2 Rossi Field Stripping Seite 2 von 4 5. Pull down the lever part way to open the bolt slightly and so that the locking bolts are sticking out the bottom of the receiver. You want to be able to see the screws that are in the left locking bolt.
  • Page 3 Be careful not to lose any of the small springs or parts. Rossi Model 92 Reassembly Reassemble in the reverse order as listed above. Assembling the bolt, ejector, and lever can be a tough job. To get them back together: 1.
  • Page 4 Rossi Field Stripping Seite 4 von 4 3. Ensure the ejector is aligned properly, then close the bolt. 4. Press forward on the lever to seat it completely into the receiver. 5. Align the holes in the bolt and lever with the pin hole in the receiver and insert the bolt pin.

Table of Contents

Save PDF