Draper AUTOLINK TRIGGER-ER Installation

A U T O L I N K T R I G G E R - E R
ART NR: 210907-ER

Installation:

To pair the AutoLink transmitter to a receiver (projection
screen with Draper-ER radio motor or Draper-ER Control box)
use an existing remote control already programmed to the
receiver.
TIP! Do the pairing process separately as a step 1 and
thereafter connect the Autolink to the projector to do the
power calibrating process as step 2.

STEP 1 - Pair the Autolink to a screen motor/Control box

a. Connect power to the AutoLink
b. Press the "P2" button under the battery lid of the
remote control x2. The motor respond with 1 jog
and 1 beep for each press (Control box blue LED flash)
c. Directly after, press P2 on the AutoLink transmitter. The
motor respond with 2 jog and 3 beep (Control box with
3 flash)
TIP! Make sure that the screen runs upwards when using
the "UP" button on the AutoLink transmitter.
STEP 2 - Cailibrating Autolink to the projector's power level
Connect the AutoLink transmitter to the projector power
input. While the projector is in "Standby mode", hold the "P2"
button on the AutoLink transmitter ca 10 sec. until it beeps
3 times.
NOTE! When pairing to a screen with built in radio motor the
motor will respond during the 10 sec but kepp hold until the
AutoLink reponds with 3 beep.
The AutoLink is now calibrated to a value of the projector's
power level + 10 W.

Function:

When the projector is turned on and the power exceeds the
calibrated effect, the AutoLink will send a "down" signal to
the screen and the LED will be red. The led will go out after
30 sec.
When the projector is turned off to standby and the power
is less than the calibrated effect level, the AutoLink will send
an "up" signal to the screen and the LED will be green. The
LED will go out after 30 sec.

Technical spec:

Rated voltage: 230VAC/50Hz
Working temp: -10-55 ˚C
Radio Frequency: 433,925MHz
Working power: 10mW
Radio range: 150 m outdoor
40 m indoor
P2
Draper Europe AB
Västervallvägen 6,
302 50 Halmstad, Sweden
www.euroscreens.se
LED
Red/green
UP/UPP