Armodilo ALUR Assembly Instructions

Setup & assembly
1

Unpacking the kiosk

Open the box
A
2

Attaching the baseplate

1. Set the kiosk onto a sturdy work
surface - front down (See yellow note)
2. Set the baseplate along the
bottom of the kiosk as shown.
3. Secure three 1/4-20 x 1" screws
through the baseplate and into the
kiosk using the supplied Allen key
4. Ensure these screws are tight
This part is
easier with
two people
Set the kiosk on the floor
3

Removing the tablet carrier

Remove ArmoLock
™
screws on both sides
A
Hold onto the bar
so it doesn't drop
Slide the tablet carrier out of the kiosk –
grabbing the two finger insets on either side,
slightly wiggle the carrier to get it started
D
Warranty & other
information available
at: armodilo.com
B
Remove foam blocks
and store for future use.
90˚
A
Remove the top bar
and security screws
B
Please retain packaging
material for future use.
A Phillips head screwdriver is required for installation
Remove base from
side panel. Remove
protective bag and
store for future use
C
For ease of installation,
ensure the baseplate is
angled at 90˚ to the kiosk.
To ensure the kiosk doesn't get scratched:
leave the kiosk in the supplied plastic bag
and place a soft material on the work surface
such as cardboard, a blanket or towels
Turn the two tabs securing
the tablet carrier out so
they are vertical
C
Set the carrier
onto a work
surface
E
Using two people,
remove kiosk from box.
D
Tighten the three 1/4-20
x 1" long screws using
the supplied Allen key
B
!
Turn tabs out